The PACEARTH set pairs 32 mm birch rings with straps that are 1.5 inches wide, which the listing says is wider than competing sets. The cam buckles have a serrated contact surface to increase the bite on the strap, and the strap length comes in 9 ft or 14.76 ft versions depending on how high your anchor is.
The tradeoff is that cam buckles are slower to adjust than carabiner systems, and the numbered straps found on rivals make it easier to match heights. Compared with the Cupbunny set, it has a heavier, wider strap but a less convenient height marking. The 1500 lb figure is a listing claim for the strap system, not a rated spec you should plan to load.
In ownership, birch rings need to be kept dry, so wipe sweat after use and store them indoors. Check the buckle teeth and the strap edges for fraying every few weeks. Longer straps are easier to hang from a high pull-up bar, but look at the 14.76 ft length only if your anchor is high enough to need it.
What works
- Wide 1.5 inch straps spread load and are less likely to dig into the hands or skin
- Cam buckle with a serrated surface bites the strap firmly under bodyweight
- 32 mm birch rings give a standard wooden grip that absorbs sweat
- 9 ft and 14.76 ft strap options fit both low and high anchor points
Watch out for
- Cam buckles take longer to set and equalize than numbered straps
- Load figures are the listing's claim, so do not treat them as a rated limit
Specs
- Ring material
- Birch wood, 32 mm thick
- Strap width
- 1.5 in (3.8 cm)
- Strap length
- 9 ft or 14.76 ft options
- Buckle
- Cam with serrated bite
- Stated load
- 1500 lb, 1000 lb on variants






